Connecting the sensors

To perform motion capture, first connect the sensors with the mocopi app.
  1. Find and launch the mocopi app and tap [START MOTION CAPTURE].
  2. Press the button on each sensor to turn the sensor on and place it on a flat surface.

    The indicator on each sensor flashes in blue.
    If the indicator does not light up or if it flashes in orange, charge the sensor before connecting it to the app.

  3. On the [Connecting the sensors] screen, tap [CONFIRM].
  4. On the [Sensor status] screen, tap [CONNECT SENSORS].

    The sensors begin connecting with the app.
    When the connection is established, the indicator on the sensor flashes in green.

  5. On the [Turning on the sensors] screen, tap [CONFIRM].

    The [Securing the sensors] screen appears.

Note

  • Make sure to turn on the Bluetooth function on your smartphone before connecting the sensors.
  • Once you start connecting the sensors, check the information displayed on the screen and do not move the sensors until they are all connected with the app.
  • When connecting the sensors, avoid placing vibrating devices (for example, a laptop PC) near the sensors.
  • If [Could not find sensors] appears, check the following.
    • If the sensors are turned off, turn them on.
    • If another Bluetooth device is connected to your smartphone, disconnect it.
    • If the sensors are connected to another smartphone, disconnect them.
    • Turn off the sensor, wait about 10 seconds, and then turn it on again.
    • Delete the sensor on the Bluetooth device list on your smartphone and then try pairing it again.
    • Restart your smartphone.
    • Reset the sensor. To reset the sensor, press the power button 10 times. When the reset is complete, the indicator flashes in red and blue alternately. The Bluetooth device information registered to the sensor is erased by the reset. Try pairing the sensor again.
  • If you cannot turn on the sensor, check the following.
    • The battery level may be low. Charge the sensor.
    • If the sensor is charged but you cannot turn on the power, press and hold the button on the sensor for 5 seconds to restart.
  • If a firmware update starts when you are connecting the sensors, wait until it ends. Firmware cannot be updated while the sensors are charging in the charging case because Bluetooth is disconnected at this time.
Go to Page Top
TP1001055238